JP Spindle Running-in Table

What is spindle running-in table?

The machine comprises a bed base, a motor, a gearbox and a spindle, which is characterized in that the spindle is installed on the headstock on the bed base, and a pressure cylinder is installed at the end of the spindle for clamping, and the pressure cylinder controls the clamping device installed at the front end of the spindle through a pull rod installed in the hollow spindle.

We all know that the spindle running-in table is a matching product of the machine tool spindle balancing machine, and the two are used together.

Why run in on the spindle running-in table?

Because through running-in, the tiny deformation caused by processing and heat treatment of the spindle can be eliminated, and the contact accuracy of the gear can be further improved and its noise can be reduced. For the gear transmission pair with high speed and heavy load, the running-in is more important.

Below is the introduction to JP spindle running-in table

It is mainly used in the state monitoring of the running-in and the running-in process of the spindle.

The equipment adopts variable frequency motor to drive the belt to drive the spindle. It can realize multi-section speed automatic running-in, each section can customize the speed and time, monitor the temperature of each sensor in the process of running-in, real-time display and generate curves, monitor the temperature change in the whole process of running-in, and has the temperature alarm function. When the temperature is too high or the sensor is disconnected, it can alarm and automatically reduce the speed or stop the machine. With running-in recording and curve printing function. Drive motor temperature monitoring and alarm function are added.

Welcome to spindle industry partners to inquire about our latest equipment and products!